doc/known_bugs_en.txt                                             2023-06-06
============================================================================





============================================================================
BUG CAD "LN tangent to 2 objs"
============================================================================
2019-09-23 MW

P20=0 0 0
C20=P(5.3780709 -14.12331019 0) P(8.966791627 -14.73005352 0)
C21=P(10.11738877 -8.898544903 0) P(14.52655815 -14.04871827 0)
L24=TNG C20 C21
P21=INT C20 C21
S22=CCV P21 C20 REV L24 C21 REV P21
L25=TNG P20 S22 MOD(3)

CAD "LN tangent to 2 objs"
- select P20
- select C21 in S22
  - selection should provide C(S22 SEG(3))


---------------------------------------
PROBLEM:
- tests basic curves of CCV, not trimmed-curve
TODO:
- Function must test if tangentPoint is inside subCurv or not

APT_TNG__
  UTO_TNG_cv_cv



---------------------------------------
2019-09-23 RF
BUG CAD "LN tangent to 2 objs"


S20=BSP P(13.15370555 1.700479482 0) P(21.94738074 4.376815326 0) P(32.80565794 0.6299451445 0)  P(46.18733758 3.765081419 0)
C21=P(7 -8 0) 8
L20=TNG C21 S20

CAD "LN tangent to 2 objs"
- select C21
- select S22
- solution nr 2
  - cannot find solution nr 2


APT_TNG__
  UTO_TNG_cv_cv





============================================================================
Send bug reports, suggestions for improvements to support@gcad3d.org

Bug Reports:
  Bug reports should be addressed to:
  support@gcad3d.org
  Please include all information required to reproduce the error cited.

  Fehlerberichte richten Sie an:
  support@gcad3d.org
  Bitte alle erforderlichen Informationen zum Reproduzieren des Fehlers anführen.



EOF